Glossary Of Terms; Unpacking And Checking Contents - Skil 3550 Manual Del Propietário

GLOSSARY OF TERMS

Workpiece
The item on which the cutting operation is being performed. The surfaces of a workpiece are
commonly referred to as faces, ends and edges.
Arbor
The shaft on which a cutting tool is mounted.
Crosscut
A cutting or shaping operation made across the width of the workpiece cutting the workpiece
to length.
Freehand
Performing a cut without a fence, miter gauge, fixture, hold down or other proper device to
keep the workpiece from twisting during the cut.
Leading End
The end of the workpiece which, during a rip type operation, is pushed into the cutting tool
first.
Ripping
A cutting operation along the length of the workpiece cutting the workpiece to width.
Revolutions Per Minute(R.P.M.)
The number of turns completed by a spinning object in one minute.

UNPACKING AND CHECKING CONTENTS

WARNING
and understood the entire owner's manual.
Model 3550 Tile Saw is shipped complete in one box.
Unpacking and Checking Contents. Separate all parts from packing materials and check each
one with the "Table of Loose Parts" to make sure all items are accounted for before discarding
any packing material.
WARNING
and are installed correctly.
To reduce the risk of injury, never connect plug to power source
outlet until all assembly steps are complete and until you have read
If any parts are missing, do not attempt to assemble the saw, plug in
power cord or turn the switch on until the missing parts are obtained
13