Skil 3550 Manual Del Propietário página 17

Top Guard Installation
1. Loosen and remove the two screws and
plastic holder (Fig. 5).
2. Make sure the mounting area, plastic holder,
and screws are clean and free from debris.
3. Place top guard arm in mounting area with
the plastic holder and two screws on top of it
(Fig. 5).
4. Tighten the screws most of the way so that
there is some movement of the guard.
5. Raise top guard in UP-position and tighten
guard locking knob.
6. Align top guard arm with blade; using rip
fence as a guide, and tighten the two screws
(Fig. 6).
7. Untighten guard locking knob and check
alignment of top guard front with blade.
8. If needed: untighten one of the screws and
align top guard with blade.
9. For proper operation; top guard should be
able to move freely UP and DOWN, without
touching the blade.
Side Extension Installation
1. Remove screw at end of extension rod
(Fig. 7).
2. Slide the extension bars on preferred side of
the table so the end of the bars pass through
the center supports.
3. Re-apply screw to extension bar and tighten.
4. Slide the extension in or out to a position where it best supports the workpiece.
5. Tighten extension locking knob.
Fig. 7
Extension
Locking Knob
Securing
Screws
Plastic
Holder
Center
support
Fig. 5
Guard
locking
Knob
Top
Guard
Arm
Fig. 6
Rip
Fence
Securing
Screws
Side Extension
Screw
Tile Saw Blade
Tile Saw Blade
17