Control Panel; Channel Control Section (Mono Input Section) - Yamaha MM 1402 Manual De Operación

Control panel

■ Channel control section (mono input section)

–14
GAIN
+10
–15
HIGH
–15
–15
LOW
0
AUX 1
0
AUX 2
L
PAN
1
2
Downloaded from: http://www.usersmanualguide.com/
1 GAIN control
1
2 HIGH, MID, LOW equalizer (3 band)
–60
–36
+15
2
3 AUX 1, 2 controls
+15
MID
+15
4 PAN control (panpot)
10
3
5 PEAK indicator
10
4
R
6 PFL switch (input channel)
5
PEAK
6
PFL
7 Channel fader
10
5
0
7
5
10
15
20
30
00
Use this knob to adjust the level of the input signal to the optimal level.
For the best balance of S/N ratio and dynamic range, adjust this knob so that
the peak indicator 5 lights occasionally.
For mic inputs connected to the XLR connector, the range is –14dB – –60dB.
For line inputs connected to the phone connector, the range is +10 – –36dB.
These knobs control high, mid and low equalization at the following frequen-
cies.
HIGH: 12kHz, maximum effect ±15dB
MID: 2.5kHz, maximum effect ±15dB
LOW: 80Hz, maximum effect ±15dB
When the knob is in the center position, the response will be flat.
These knobs control the level of the signal that is output to the AUX buses.
Since AUX1 is placed before the channel fader, it will be unaffected by the
position of the channel fader. Since AUX2 is placed after the channel fader, it
will be affected by the channel fader level. By outputting a signal only from
AUX SEND 1 or AUX SEND 2 and not from the ST OUT jacks, you can also
use these as supplementary outputs.
This knob assigns the signal of each channel to the STEREO L and R buses,
determining the stereo location of the sound.
This indicator detects the level of the signal at a point after the EQ (pre fader).
It will light red at 3dB before clipping to warn that the signal is approaching
clipping level.
This switch allows you to monitor the signal of the input channel at the pre
fader level. You can use headphones or MONI OUT to conveniently check
the input signal of a specific channel, or trouble-shoot a channel that is having
problems.
This fader controls the output level of the input channel signal, adjusting the
volume balance between channels. Faders of channels not in use should be
pulled down.
PHANTOM
OFF
ON
(MIC IN)
PHANTOM
(PHANTOM)
MIC IN
HA
1–6
GAIN
LINE IN
PAD
1–6
(+48V)
PEAK
EQ BA
PAN
AUX 2
AUX 1
(+V)
PFL