Couture Creations GoPress and Foil Manual Del Usuario página 5

HOT FOILING WITH CUTTING DIES
Accessories needed:
• Standard wafer thin die of your choice
• Heat activated Foil
• Cardstock
1.Turn the mains power switch on for your foiling machine. A red light will come on when
plugging in. With your Heating Platform connected to your base unit, when you press
the button on the base unit the red light will commence to flash on and off. This light will
then turn green once it reaches working temperature ( this will take approximately 5 – 6
minutes ). The machine will automatically switch off after the machine is left unused for
over 25 minutes ( The red indicator light will come on ).
2. Please note that the heating platform will maintain a maximum temperature of
approximately 90°C / 194°F as it has a built in automatic thermostat.
3. Lift up the Heating Platform clear protector lid. Place your standard wafer thin die
on the Heating Platform (facing upwards) on the black non slip surface mat. Close the
Heating Platform clear protector lid.
4. Let your standard wafer thin die heat for approximately 1 minute. While your foiling
machine heats up prepare your cardstock and cut your heat activated foil to desired size
in preparation for your foiled die image.
5. Lift up the Heating Platform clear protector lid and place the heat activated foil on top
with the coloured side of the foil facing down.
6. Place card stock, or your card or other desired material presentation side down on top
of your desired standard wafer thin die . Place a shim (piece of large cardstock) over your
project.
7. Close the Heating Platform clear protector lid, remove it from the base unit and place
the platform into the opening of your cutting machine. Wind through as per normal. ***
NOTE: YOU ONLY NEED A VERY SLIGHT AMOUNT OF PRESSURE, IF YOU HAVE
TOO MUCH PRESSURE YOU WILL DAMAGE YOUR HEATING PLATFORM.
8. You will now have the chosen image of your standard wafer thin die foiled into your
cardstock or desired item.
9. Remove the foil from the surface of the desired material and your foiled
image is now complete!
THE METAL CUTTING DIE WILL BE HOT. PLEASE ONLY USE THE
*
PICK N LIFT 3 IN 1 MAGIC TOOL TO PICK UP YOUR PLATE.
All manuals and user guides at all-guides.com
AND THE GOPRESS AND FOIL
PAGE 5