Couture Creations GoPress and Foil Manual Del Usuario página 7

NOTE: YOU DO NOT NEED TO HEAT THE PLATE FOR LETTERPESS.
DO NOT TURN THE GOPRESS AND FOIL ON FOR THIS METHOD.
Accessories needed:
• Hotfoil Stamp
• Paper or Cardstock
1. Lift up the Heating Platform clear protector lid. Place your Hotfoil Stamp
(facing upwards) on the black non slip surface mat.
2. Place your cardstock presentation side down on top of your desired Hotfoil Stamp.
Place a shim (piece of large cardstock) over your project piece of cardstock.
3. Close the clear platform protector lid and place the platform into the opening of your
GoCut & Emboss Machine. Wind through as per normal.
NOTE: YOU ONLY NEED A VERY SLIGHT AMOUNT OF PRESSURE, IF YOU HAVE
TOO MUCH PRESSURE YOU WILL DAMAGE YOUR HEATING PLATFORM.
4. You will now have the chosen image debossed into your cardstock.
Your letterpress image is now complete!
5. You can also add ink to your Hotfoil Stamp which will create a debossed and inked
impression on paper, cardstock and your other favourite mediums.
Inking your chosen Hotfoil Stamp before placing down the cardstock.
Try
Pigment ink works best with your Hotfoil Stamp as other ink may dry too
quickly. Ensure not to over ink and clean off all the ink after use and dry your
Hotfoil Stamp to avoid ink drying in the intricate design.
1. Your Heating Platform should glide smoothly through your
Note
die cutting machine.
2. The Hotfoil Stamp is not meant to cut out an image, you will
have a foiled debossed impression on your cardstock.
3. There will not be the same pressure produced as when cutting a
normal die.
All manuals and user guides at all-guides.com
LETTERPRESS
WITH THE GOPRESS AND FOIL
PAGE 7