Makita DUR182L Manual De Instrucciones página 13

MAINTENANCE
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
attempting to
maintenance on the trimmer. Failure to switch
off and remove the battery cartridge may result in
serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
Use only 2.0 - 3.0 mm (0.08" - 0.12") diameter
•
nylon cord. Never use metal wire, rope or the
like. Use of
recommended nylon cord may cause damage to
the trimmer and result in serious personal injury.
013822
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
1
013823
Cut a nylon line in 3-6m (10 - 20 ft). Fold the cutting line
in two halves, leave one of half longer 80-100 mm (3 - 4
inches) than another.
perform inspection
something other than
1. 80-100 mm
or
013824
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2
channels provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for left hand direction indicated by
LH.
the
013825
Wind all but about 100 mm (4") of the cords, leaving the
ends temporarily hooked through a notch on the side of
the spool.
013826
Mount the spool on the cover so that the grooves and
protrusions on the spool match up with those on the
cover. Now, unhook the ends of the cord from their
temporary position and feed the cords through the
eyelets to come out of the cover.
013827
13