Installing Batteries - Zenith Heath SL-6050-WH Manual Del Usuario

180° AND 240° MOTION SENSORS
180° Motion Sensor
Model: 6030
Features:
• No wiring required.
• 180° - Up to 70 feet sensing range
• 240° - Up to 100 feet sensing range
• Adjustable sensitivity.
• Day/Night or Night only operation.
• Test mode.
• 180° Uses 2 AA batteries.
• Wall or eave mount.
• Controls receivers up to 100 feet (30 m) away.
Select Night or 24 Hour Mode
These motion sensors are able to detect motion day and night or
night only. To set the detection mode, remove battery compart-
ment cover:
• 180° Model - Slide cover down to remove.
• 240° Model - Remove screw and lift cover to remove.
Remove batteries if necessary. Slide the DETECT switch to either
the DAY/NIGHT or NIGHT ONLY position. Replace battery compart-
ment cover by reversing the above instructions.
DAY NIGHT
NIGHT ONLY
1 2 3 4
DETECT
CODES
180° Motion Sensor
(Rear View)
Battery Compartment
200668-03
240° Motion Sensor
Models: 6032 and 6062
• 240° Uses 2 AAA batteries.
Cover Screw
Detect
Control
CODES DETECT
DAY NIGHT
1 2 3 4
NIGHT ONLY
240° Motion Sensor
(Rear View)

Installing Batteries

Before mounting motion sensor, remove battery compartment
cover:
• 180° Model - Slide cover down to remove.
• 240° Model - Remove screw and lift cover to remove.
Install 2 AA batteries (180°) or 2 AAA batteries (240°) according to
polarity markings inside the battery compartment. Replace battery
compartment cover by reversing the above instructions.
Installing Motion Sensor
1. Install motion sensor mounting bracket where motion detection is
desired. Attach motion sensor mounting bracket to a sturdy object
(i.e. tree, post, house, etc.) using two screws provided. Make
sure unit has an unobstructed view. Note: Attach mounting
bracket vertically if connecting to a curved surface such as a
post.
2. Install motion sensor to mounting bracket. Using a Phillips-head
screwdriver, loosen the clamp screw on the mounting bracket.
Insert swivel ball mount on motion sensor into mounting bracket
socket (Note: You should hear a snap). Aim motion sensor toward
area where detection is desired. Tighten clamp screw.
IMPORTANT: The motion sensor must be mounted with the bottom
cover facing down in order to maintain water tightness.
Mounting
Bracket Socket
Clamp
Screw
Swivel Ball Mount
Sensor
Installing Motion Sensor
(180° Motion Sensor Shown)
3
Mounting Bracket
Mounting Screw
Nut
Continued