Functional Description; Fitting The Receiver Battery; Installing The Emitter - Multimetrix CBF01 Manual De Instrucciones

English

3. Functional description

3.1 Fitting the receiver battery

Remove the cover from the battery housing by sliding it in the direction
of the arrow. Fit a 9 V (6F22 or equivalent) battery in the housing taking
care to respect the poles. Refit the cover.

3.2 Installing the emitter

Test of a wall mains outlet circuit:
Connect both connectors on the mains cable adapter to the
emitter unit.
Connect the two pole plug to the mains wall outlet to be tested.
Carry on at step 4. below.
Test of a lighting circuit:
1. Power off the installation.
2. After it has cooled, remove the light bulb from the circuit to be
tested and replace it with an adapter with the same base.
Connect both connectors on the adapter to the emitter unit.
3. Power on the installation.
4. The red LED on the emitter should turn on (fig. 2)
5. Turn the receiver's rotating switch to the rear from the OFF
position until it clicks. The green LED should turn on,
detection sensitivity is at its maximum. If you continue turning
the switch to the rear the sensitivity of the receiver will lessen
gradually.
6. Place the receiver by the emitter (fig. 3). The receiver will
issue a sound signal and its green LED will flash.
7. Power off the installation before disconnecting the adapter.
CBF01 15