Multimetrix CBF01 Manual De Instrucciones página 18

English
2. After having located the circuit breaker (or the fuse), trip the circuit
breaker (or remove the fuse). Repeat the detection with the
receiver set to its maximum sensitivity for this circuit breaker (or
fuse). If the receiver no longer detects a signal, the circuit breaker
that you have tripped (or the fuse that you have removed) is the
one that protects the circuit selected by the emitter. On the other
hand, if the receiver can still detect the signal for the circuit breaker
(or fuse), then this circuit breaker (or fuse) is not the one that
protects the selected circuit.
3. Disconnect the emitter unit from the mains wall outlet or the light
bulb base (and put back the light bulb)
4. Power back on by rearming the circuit breaker or refitting the fuse.
CBF01
Fig.4
17