Changing The Password; Troubleshooting - Samsung DVD-P250K Manual De Instrucciones

C S
H A N G I N G E T U P M E N U

Changing the Password

1
With the unit in Stop
mode, press the MENU
button.
2
Press the $/❷ buttons to
select Setup, then press
the ❿ or ENTER button.
Setup
3
Press the $/❷ buttons to
select Parental Setup,
then press the ❿ or
ENTER button.
Setup
The Enter Password
screen appears.
Enter your password.
4
Press the $/❷ button to
select Change
Password, then press the
❿ or ENTER button.
Enter your new password.
Re-enter the new
password again.
CHANGE PASSWORD
Enter New Password
- - - -
0 ~ 9
CHANGE PASSWORD
Re-enter Password
- - - -
0 ~ 9
ENG-54
To make the setup menu disappear, press the
MENU button.
Note
If you have forgotten your password, see
"Forgot Password" in the Troubleshooting Guide.
C h a p t e r 7
R
E F E R E N C E

Troubleshooting

Before requesting service (troubleshooting), please check the following.
Problem
No operations can be • Check the batteries in the remote control.
They may need replacing.
performed with the
• Operate the remote control at a distance of no more than 20 feet.
remote control.
• Remove batteries and hold down one or more buttons for several minutes to
drain the microprocessor inside the remote control to reset it. Reinstall
batteries and try to operate the remote control again.
Disc does not play. • Ensure that the disc is installed with the label side facing up.
• Check the region number of the DVD.
5.1 channel sound is • 5.1 channel sound is reproduced only when the following conditions are met. :
not being reproduced. 1) The DVD player is connected with the proper Amplifier
2) The disc is recorded with 5.1 channel sound.
• Check whether the disc being played has the "5.1 ch" mark on the outside.
• Check if your audio system is connected and working properly.
• In a SETUP Menu, is the Audio Output set to Bitstream?
• The features or action cannot be completed at this time because:
1. The DVD's software restricts it.
The icon appears
on screen. 2. The DVD's software doesn't support the feature (e.g., angles).
3. The feature is not available at the moment.
4. You've requested a title or chapter number or search time that is out of range.
Disc Menu doesn't appear. • Check if the disc has a Menu.
Play mode differs from the • Some of the functions selected in the Setup Menu may not work properly if the
Setup Menu selection.
disc is not encoded with the corresponding function.
The screen ratio
• The Screen Ratio is fixed on your DVDs.
cannot be changed.
• Make sure you have selected the correct Digital Output in the Audio Options
No audio.
Menu.
The screen is blocked
• Press the button for more than 5 seconds under no disc inside.
All settings will revert to the factory settings.
Forgot password • Press the button for more than 5 seconds under no disc inside.
All settings including the password will revert to the factory settings. Don't use
this unless absolutely necessary.
If you experience other • Go to the contents and find the section of the instruction book that contains
problems. the explanations regarding the current problem, and follow the procedure once
again.
• If the problem still cannot be solved, please contact your nearest authorized
service center.
The picture is noisy or
• Make sure that the disc is not dirty or scratched.
distorted
• Clean the disc.
ENG-55
Action
Page
P4
P7
P16
P48~49
P43~54
P50~51
P48~49
P17
P52~54
P2