Sandrigarden SG HT/A Serie Manual De Instrucciones página 18

GB
B10 – SAFETY DEVICES
B10.1 – The THROTTLE TRIGGER
LOCKOUT (see Brush Cutter
manual) stops accidental operation
of the throttle control lever.
B10.2 - Engine power ON/OFF
SWITCH (see Brush Cutter
manual).
DANGER! The cutting device
continues to spin for a while even
after the on/off switch has been
turned to the OFF position.
Hold both handles firmly until the
cutting device has come to a com-
plete stop. See section STARTING
AND STOPPING.
3. DESCRIPTION OF MACHINE
PARTS FIG.1
1) Shaft
2-3) Gearbox
4-5) Cutting blades
6) Blade holder bar
7) Shaft clamp locking screw
8) Shaft centring screw
9) Blade guards
10) Tilting handle
11) Tilting selector switch lockout knob
12) Tilting angle selector switch
18
HEDGE TRIMMER OPERATING MANUAL
4. ASSEMBLY
1) The packaging box contains the gearbox and
the blades, separated from the shaft (see fig. 2)
FITTING THE BLADE UNIT ONTO THE
SHAFT
1) Fit the HEDGE TRIMMER (fig. 3 item 1) onto
the bottom drive shaft (fig. 3 item 2), making sure
that the drive spindle (fig. 3 item 3) is correctly
located inside the gearbox housing. WARNING
The locating hole (fig. 3 item A) on the shaft must
match the position of the gearbox hole (fig. 3
item B).
2) Firstly fit and tighten the locating screw (fig. 4
item 1), then firmly tighten the clamp screws (fig.
4 item 2).
FITTING THE WHOLE HEDGE TRIMMER
UNIT ONTO THE MOTORISED UNIT
WARNING! The hedge trimmer can
be fitted in 3 different positions
matching the 3 holes located in the top shaft
clamp (fig.6).
A - 0° (fig.7)
C - 180° (fig.8)
POSITION A
1
A
6
4 5
3 2