Sandrigarden SG HT/A Serie Manual De Instrucciones página 19

1) Slacken the knob (3) on the clamp (1) located
on the motorised unit.
2) Move closer and introduce the shaft (2) in
the clamp, making sure the flexible peg (5)
matches the hole (4). Push fully down until the
flexible peg comes out of the hole (see stage
6). Fully tighten the screw knob, as shown in the
picture. This fitting position A = 0° is suitable
for usage shown in figures 13-14.
Also see fitting position B = 90° suitable for
usage shown in Fig.13.
POSITION C
C
1
6
1) Slacken the knob (3) on the clamp (1) located
on the motorised unit.
2) Move closer and introduce the shaft (2) in
the clamp, making sure the flexible peg (5)
matches the hole (4). Push fully down until the
flexible peg comes out of the hole (see stage
6). Fully tighten the screw knob, as shown in the
picture.
This fitting position C = 180° is suitable for
usage shown in fig.15.
WARNING! Start the engine only after
connecting the bottom drive shaft to
the upper drive shaft. Make sure the clamp
screw knob (fig. 6 item 1) is firmly tightened.
HEDGE TRIMMER OPERATING MANUAL
4 2
5
3
WORKING ANGLE ADJUSTMENT
The blades may be adjusted in 8 different
positions; up (fig. 7) and down (fig. 8).
WARNING! The working angle
adjustment operation must be
carried out only when the blades have
come to a stop (engine off).
WARNING! When the hedge trimmer
is in operation, the reduction unit
will heat up. Do not touch the box
without safety gloves.
Danger of burns
1) Slacken the tilting selector switch lockout knob
(fig. 9 item 1).
2) Tilt the blades in the desired position (fig. 10)
3) Tighten the knob.
BELT SLING AND FIXING RING (Fig. 11)
(See the Brush Cutter manual. The same
conditions apply).
5. REFUELLING
(see the Brush Cutter manual. The same
conditions apply).
GB
19