Caratteristiche Tecniche - Urmet 1083/80 Guia Del Usuario

1 - Spostare il dip-switch 1 in posizione ON
2 - Assegnare alla decodifi ca speciale un codice utente da 0 a 127 agendo sui dip-switch CODE
§
Per impostare il codice desiderato utilizzare i dip-switch da 2 a 8 (2 = bit più signifi cativo - 8 = bit meno
signifi cativo).
Il codice utente può essere lo stesso già impiegato nei posti interni dello stesso appartamento.
A programmazione effettuata, premendo il pulsante remoto (PC) viene inviato al centralino un allarme panico
con l'indicazione della colonna in cui è installata la decodifi ca e il codice utente che è stato programmato
(CODE).
Contemporaneamente il relé viene attivato in funzione delle impostazioni effettuate con le modalità di
commutazione.

CARATTERISTICHE TECNICHE

Tensione di alimentazione: ............................................................................................................36 ÷ 48Vcc
Assorbimento a riposo: ................................................................................................................ 3,0mA max
Assorbimento max: ....................................................................................................................... 30mA max
Temperatura di funzionamento: ............................................................................................ - 10°C ÷ + 50°C
Conformità normativa: ..................................................................................... EN 61000-6-3, EN 61000-6-1
Commutazione contatto C-NC-NA: ................................................................................................ 30Vcc 5A
8
The special decoder Ref. 1083/80 is dedicated to 2Voice system and allows to activate electric loads by
means of a 230Vac 5A contact relay with commands (events) sent by users with apartment stations, call
stations or switchboard.
The main uses are:
• Driveway passages opening.
• Stairs lights lighting.
• Electric loads activation/deactivation.
Device main features are:
• Monostable operating mode with activation time adjustable from 1 second to 16 minutes, or toggle
mode.
• Activation with system events (4 maximum, with competence areas jumper to C or Q) programmable by
the installer.
• Possibility of activation with user events (32 max. with competence areas jumper to S), programmable
by the installer.
• A remote button can be connected for activation.
250Vca 5A
A - User code dip-switch used to identify the decoder in the system
B - Competence area jumpers:
S = only the device used to acquire the event
C = all devices of the riser column used to acquire the event
Q = any system device
C - Switch mode jumper
M = monostable
T = toggle
D - Programming button and led
E - Trimmer used to adjust the activation timer in monostable mode (M)
F - Remote button connection terminal pins (PC)
G - Line connection terminal pins (LINE)
H - Terminal pins of relay contact used to activate electric loads (C-NC-NA)
INSTALLATION
The special decoder can be installed in a service panel on DIN rail (6 18mm DIN modules) or wall mounted
with screws and screw anchors (not provided).
For installation, follow general installation instructions of 2Voice system in the system booklet provided with
DS1083-019A DS1083-019A
C
B
A
ON
CODE S C Q M T PROG TIMER
Sch.1083/80
NA NC C LINE
H
ENGLISH
D
E
PC
F
G
9