Remington PrecisionPro MB-200 Manual De Instrucciones página 4

27508_MB200/300_IB 8/31/05 4:40 PM Page 6
Operating Your Trimmer
Charging/Recharging
To recharge these models, use only the charging
adapter provided.
Turn the trimmer off. Insert the adapter plug
into the bottom of the trimmer, then plug the
adapter into an electric wall outlet. The
charging indicator will glow green, indicating
unit is charging. A full charge will take
approx. 14-16 hours.
Your trimmer cannot be overcharged. You
may leave it plugged in between uses.
However, if the trimmer is not going to
be used for an extended period (2 weeks),
unplug the unit and recharge when
resuming use.
Charge the trimmer at temperatures
between 40 – 90°F, to avoid adversely
affecting battery life.
In order to preserve the life of the batteries,
they should be fully discharged every six
months and then fully charged for 24 hours.
Nickel-Cadmium batteries included (see
battery removal section for proper disposal
of batteries)
6
Corded Rechargeable
Operation
(MB-200)
Plugging in the adapter cord will not provide
power to the trimmer, but only recharge the
batteries.
Hair Length Selector and
Removable Trimmer Guard
Attachment
NOTE: trimmer guard must be attached to
the trimmer in order to use the hair length
selector.
The hair length selector and trimmer guard
attachment ensures precise trimming and
has nine adjustable positions:
Setting Beard Style Length
1 Stubble look 1.5 mm 0.06"
2 2.5 mm 0.1"
3 Short 4 mm 0.16"
4 5.5 mm 0.22"
5 Medium 7 mm 0.28"
6 9 mm 0.35"
7 11 mm 0.43"
8 Long 14 mm 0.55"
9 18 mm 0.71"
To adjust, roll the "Zoom Wheel" toward
Trimmer Guard Attachment
the top of the trimmer to adjust for longer
Remove trimmer guard attachment if you are:
length, and toward the bottom of the
defining hairline edges such as sideburns,
trimmer for shorter length.The wheel will
trimming the nape of your neck, trimming
click into one of nine positions.
your beard line on front of neck, or if you
Begin trimming at one of the longest want to clean cutter assembly.
settings (#8 or #9 to avoid accidentally
trimming hair too short). As you become To remove:
familiar with the settings, you can then
select your desired length setting.
To replace:
NOTE: the trimmer guard attachment can
only be placed on the trimmer one way; if it
does not fit properly, remove and reverse it.
Be sure the trimmer is in OFF position.
While holding trimmer in one hand, and
holding the "Zoom Wheel" to prevent it
from turning, gently pull the trimmer
guard attachment away from the
trimmer. The guard can be removed
and replaced on any setting.
Be certain trimmer is in OFF position.
While holding the trimmer in one hand,
and holding the "Zoom Wheel" to prevent
it from turning, slide the guard over the
top of the trimmer until it "clicks" into
position.
7