How To Use - Remington PrecisionPro MB-200 Manual De Instrucciones

27508_MB200/300_IB 8/31/05 4:40 PM Page 8

How to Use

Trimming Beards
Before you begin, comb your hair in the
direction that it grows so that the hairs
are at their maximum height and facing
in the same direction.
Determine how much hair you want to
cut and position the hair length selector
accordingly. Remember, until you are
familiar with using the trimmer, it's
always better to select a longer hair
setting initially in order not to trim too
much hair.
Turn the unit's power switch to ON, and
begin trimming.
When finished trimming, turn the unit's
power switch to OFF.
To Trim the Beard's Hair
Length
Trimmer guard attachment is on.
Turn the trimmer so the front of the
cutting unit ("Zoom Wheel" side) is
facing away from you.
Start trimming under your chin and,
following your jawbone line, work toward
your ear and upper beard line using an
upward motion. Allow the hair length
selector attachment to follow the
contours of your face.
You may trim either
against or with the
direction of beard
growth, whichever
is preferred.
To Define the Beard Line
Remove trimmer guard attachment.
Hold trimmer vertically with cutting
blades facing you.
8
Start with edge of beard line. With
the cutting blades resting lightly
against your skin, use
motions towards edge of
beard line to trim it to
desired location in facial
area and away from
beard in neck area.
To Thin and Taper the Beard
Trimmer guard attachment is off.
Use the unit's styling comb or a small
comb and hold the beard hairs in place
while trimming.
Holding the trimmer
hoizontally with the
cutting unit facing away
from you, move
the trimmer along the
length of the comb.
Creating the "Stubble Look"
Trimmer guard attachment should be
on and set to position 1 (1.5 mm) or
2 (2.5 mm).
Hold trimmer horizontaly
with the cutting unit
facing either up or
down.
Trim hairs using an
upward or downward
motion against or with
the direction of hair
growth, whichever
is preferred.
For an even closer
"stubble look," remove
the hair length selector
attachment and repeat
the previous two steps.
However, caution must be taken not
to remove too much hair, creating a
"blotchy" look.
To Trim Mustache and
Sideburns
with the Pop-Up Trimmer (MB-300)
The small size of this trimmer makes edging
and defining mustaches and cutting stray
hairs quick and easy.
Remove guard attachment
Comb hairs outward so they are at their
maximum height.
Open the pop-up
trimmer by sliding the
trimmer switch upward.
Hold trimmer perpendi-
cular, as shown,
to achieve desired line
above the lip.
Trim any stray hairs.
Attention: Main cutter is
still operating while pop-
up trimmer is in use.
Close trimmer by sliding
trimmer switch down.
Turn trimmer OFF.
Without trimmer guard attachment
Remove trimmer guard attachment.
Place a finger on upper lip only to lift
hair up, away from skin.
Trim hairs using an
upward motion.
After achieving desired
length, use a downward
motion to blend
mustache hairs.
NOTE: Use slow and light pressure. Too
much pressure may trim off more hair
than desired.
Turn trimmer off.
To trim sideburns
Comb sideburns following the direction
of your hair growth.
Be certain trimmer guard attachment
is ON.
Hold trimmer vertically with front of
trimmer facing you.
Trim sideburns using a downward
motion.
Turn trimmer OFF.
Trimming the Nape of Your
Neck
You will need a hand mirror for this
operation if performing it alone. The
mirror is not necessary if trimming is
performed by a second person.
Remove the hair length selector
attachment.
Use your fingers to lift the hair at the
base of your head up off the neck. Your
index finger should be covering the roots
of the hairs you are lifting to prevent
accidental removal by trimmer.
Using your other hand, hold the trimmer
horizontally to the base of your neck with
the cutting unit facing up, and move the
trimmer along the length of the neck until
the unit touches your finger covering the
hair roots at the base of your head.
Repeat this procedure for the entire area
of the neck. Be sure to move the unit
slowly when performing this operation
and to keep the hair roots at the base of
your head out of the way
of the trimmer.
Use the hand mirror to
inspect the results of the
operation and ensure all
hairs along the nape of
the neck have been
trimmed.
9