ARENDO 304530 Manual De Usuario página 24

5. Commissioning and use
Connect the power cord to a properly wired power socket. First proceed as
described in Section "3 Commissioning".
Ensure that the power plug has been inserted. Insert up to two toast slices into
the toast slot. Press the "Slide switch" down until it clicks into place. The currently
adjusted degree of browning is shown in the display. Press the "Degree of brown-
ing" button till the desired level is shown in the display. The heating elements
warm up and the toasting process begins.
Once the process is complete, the "slide switch" automatically jumps back to its
original position. This means that the toasting process has finished and the bread
slices can be taken out carefully.
If the degree of toasting is not satisfactory, adjust it again and repeat the toasting.
In this case, ensure that the toast does not get burnt. If the desired degree of
toasting has already been attained, you may then end the process at any time by
pressing the "CANCEL" key.
6. Bread roll attachment
Bread rolls, baguettes and loaves are too large to place in the toaster slot. Always
use the bread roll attachment for this purpose.
Note: Ensure that the crumb collector has been inserted correctly.
Before toasting on the bread roll attachment, ensure that the toaster has cooled
down completely. Ensure that no toast has been inserted into the "toast slot"
when using the bread roll warming rack, as otherwise this can result in fire.
If you do not use the bread roll attachment, remove it.
Generally, more time is required to achieve the desired degree of browning when
using the bread roll attachment. It is also advisable to turn the items on the bread
roll attachment.
7. Adjusting the Degree of toasting
The "Degree of browning" button allows you to specify the duration after which
the toaster should automatically shut down. The longer the appliance is switched
on, the darker will be the bread at the end of the browning time.
24
English