Sunbeam SD113232 Instrucciones De Montaje página 8

H
47a
JR
JR
H1
Orifice
47a
Hardware shown actual size
(6) Qty.
JR
Orifices inside of
H2
venturi tubes
Valve
heat shield
H3
GF
Inside
(1) Qty.
H
Remove the following parts from the carton:
One HEAT SHIELD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(47a)
One "I" TENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(61)
Slide the HEAT SHIELD (47a) over the the Valve. See detail H1. Place the
Control Panel on the frame (place the HVR hose inside the front panel) insert
JR
the orifices on the valve inside of the Burners' venturi tubes. IMPORTANT: The
orifices must be inside the venturi tube. See detail H2.
Secure the Control Panel to the legs with four screws (JR). From inside frame
secure the bottom flange of the Control Panel and the Front panel top flange
together with one push in fastener (GF). See detail H3.
Place the "I" TENT (61) in the Bottom Casting over the Burner and secure with
two screws (JR). See detail H4.
H4
JR
(Pg. 8) 1141-1986BX
JR
61