Publicidad
Idiomas disponibles
Idiomas disponibles
J
J
Remove the following parts from the carton:
One FRONT BASKET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(22)
One PUSH BUTTON IGNITER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(26)
Two MAIN ELECTRODE WIRES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(26b)
Push the MAIN ELECTRODE WIRES (26b) onto the main burner electrodes, located under the
bottom casting.
Thread the Main Electrode Wires through the igniter hole in the Control Panel. Push the round
connecters onto the round and flat pins on the PUSH BUTTON IGNITER (26). See detail J1.
Snap the Push Button Igniter into the Control Panel. Test: A spark should appear at electrode
tip.
If the spark does not appear.
26b
- Check the wire connections to the Igniter.
26b
- Check the wire connections to the main burner electrodes.
Hook the FRONT BASKET (22) Into the front panel. See detail J2.
J2
J1
26
22
(Pg. 9) 1141-1986
Publicidad
