Connecting; Connecting With A Vcr/15K Rgb/Component/Progressive Component Equipment - Sony VPL-VW11HT Manual De Instrucciones

Connecting

When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out by the plug, not the
cable itself.
Connecting with a VCR/15k RGB/
Component/Progressive
Component Equipment
This section describes how to connect the projector
with a VCR, external active speakers, and 15k RGB/
component/progressive component equipment.
Also refer to the instruction manuals of the equipment
to be connected.
Left side
CONTROL S IN VIDEO IN
PLUG IN POWER S VIDEO
TRIGGER
G/Y B/C
REMOTE
RS-232C G/Y B/C
(FOR SERVICE USE)
S-Video cable
(not supplied)
to S video
output
VCR
VIDEO
INPUT A
/P R/C P SYNC/HD VD
B B R/ R
INPUT B
/P R/C P SYNC/HD VD
B B R/ R
Video cable
(not supplied)
Active speakers
to video
output
Left side
CONTROL S IN VIDEO IN
PLUG IN POWER S VIDEO
TRIGGER
G/Y
REMOTE
RS-232C G/Y
(FOR SERVICE USE)
to RGB/
component/
progressive
component
output
15k RGB/Component equipment
Notes
• Set the aspect ratio using ASPECT in the INPUT
SETTING menu according to the input signal.
• To connect a 15k RGB/component/progressive
component equipment, select the COMPUTER/
COMPONENT/DTV YP
INPUT-A or INPUT-B in the SET SETTING menu
according to the input signal.
For details on setting, see page 27 (GB).
• You can connect a high definition equipment. The
connection method is the same as above.
Connecting
VIDEO
INPUT A
B/C /P R/C P SYNC/HD VD
B B R/ R
INPUT B
B/C /P R/C P SYNC/HD VD
B B R/ R
Pin Cable
(not
supplied)
Active speakers
P /DTV GBR in the
B R
15
(GB)