The Install Setting Menu - Sony VPL-VW11HT Manual De Instrucciones

The INSTALL SETTING Menu

The INSTALL SETTING
Menu
The INSTALL SETTING menu is used for changing
the settings of the projector.
INSTALL SETTING
KEYSTONE MEM: OFF
DIGIT KEYSTONE: 0
INSTALLATION: FLOOR-FRONT
CINEMA BLACK: ON
LAMP TIMER: 234h
KEYSTONE MEM
ON: DIGIT KEYSTONE setting is stored.
The data is retrieved when the projector power is
turned on. The setting will remain the same every
time.
OFF: DIGIT KEYSTONE is reset to 0 when the
power is turned on the next time.
DIGIT KEYSTONE
Corrects the trapezoid caused by the projection angle.
If the base edge is longer, set a negative value; if the
upper edge is longer, set a positive value to square the
image.
Note
If "ZOOM", "FULL" or "NORMAL" have been
selected in the ASPECT of the INPUT SETTING, you
can change the trapezoid.
28
(GB)
INPUT-A
INSTALLATION
Sets to reverse the picture horizontally or vertically.
FLOOR-FRONT: The picture is not reversed.
CEILING-FRONT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed
horizontally.
CEILING-REAR: The picture is reversed
vertically.
Note
In case of using a mirror, be careful of installation
since the picture may be reversed.
CINEMA BLACK
Switches the lamp wattage during projection.
OFF: Normal wattage.
ON: Enhances the black by reducing the lamp
wattage.
Notes
• It will take a few seconds for the projector to change
the lamp wattage during projection.
• If the CINEMA BLACK is set to ON, it starts with
OFF when the power is turned on, then changes to
ON after a while.
LAMP TIMER
Indicates how long the lamp has been turned on.
Note
This only displays the time. You cannot alter the
display.