Steam Ironing; Setting The Temperature - TEFAL PRO MINUTE AQUAPLUS Manual Del Usuario

021472-NOTICE PRO MINUTE AQUAPLUS
The first time the
appliance is used, there
may be some fumes and
smell but this is
not harmful. They will not
affect use and will
disappear rapidly.
Operating the control panel
• Green light flashes: the boiler heats up.
• Green light on: the steam is ready –
• Red light "water tank" on: the water tank is empty –
• Orange light "boiler rinse" flashes: rinse the boiler – fig.11.
Use

Steam ironing

• Place the iron's temperature control slide according to the type of fabric to be
ironed (see table below).
• The thermostat light comes on. Be careful ! The steam generator is ready when
the thermostat light goes out and when the green "steam ready" light stays on.
• Adjust the steam output control dial (located on the control panel).
• While ironing, the light on top of the iron and the steam ready light turn on and
off, according to the heating needs without interrupting the use.
• To obtain steam, press on the steam control button on top of the iron handle
and keep it pressed – fig.8. The steam will stop when you release the button.
• When starting, and regularly while it is being used, your steam generator's
electric pump injects water into the boiler. It makes a noise but this is quite
normal. You may also hear a clicking noise which is the steam valve opening.
Again this is normal.
• Always spray starch onto the reverse side of the fabric to be ironed.
4
3/01/07 9:08
Using your steam generator
• Completely unwind the power cord and the steam cord from its storage space.
• Lower the retaining hoop to unlock the safety catch –
• Plug in your steam generator to an earthed socket.
• Press on the on / off switch. The green light (located on the control panel) flashes
flashes and the boiler heats up –
When the green "steam ready" light stops flashing (after 2 minutes
approximately), the appliance is ready.
fig.7.
fig.9.
SETTING THE TEMPERATURE CONTROL SLIDE AND STEAM OUTPUT CONTROL DIAL
ACCORDING TO TYPE OF FABRIC TO BE IRONED:
Type of fabric
Linen, Cotton
•••
Silk, Wool
••
Synthetics,
Polyester,Acetate,
Acrylic, Polyamide
•
Page 4
fig.3.
fig.7.
Do not place the iron on a
metal support.When
taking a break from
ironing, always place
the iron on the iron rest
plate of the unit. It is
equipped with non-slip
pads and has been
designed to withstand
high temperatures.

Setting the temperature

Setting temperature Setting steam output
control control dial