medi SAK Manual Del Usuario página 5

making sure that it is not pulled too
tight (fig. 4).
• The height of the pad can be adjusted
by means of the hook and loop
fasteners on the ends of the strap. The
medically correct position can
therefore be achieved for all body sizes
(fig. 5).
• Figure 6 shows the correct fit of the
medi SAK. The angle of abduction can
be reduced by letting out some of the
air. The pelvic strap, which goes
around the body and the pads, is an
additional means of fixing the pad to
the body.
• Finally, stick the round patch over the
valve.
Note
Do not touch the cushion with pointy
objects. It could deflate or burst.
Care instructions
Remove the inflatable inner cushion
before washing. Hook and loop fasteners
should be closed for washing. Soap
residues, lotions and ointments can
cause skin irritation and material wear.
• Pillow case, bag and straps can be
washed by hand, preferably using
medi clean washing agent.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    
Storage instructions
Please keep the brace in a dry place and
do not expose it to direct sunlight.
Material composition
Polyamide
Liability
The manufacturer's liability will become
void if the product is not used as
intended. Please also refer to the
corresponding safety information and
instructions in this manual.
Disposal
The product can be disposed of
in the domestic waste.
Your medi team
wishes you a quick return to full fitness.
In the event of any complaints regarding
the product such as damage to the fabric
or a fault in the fit, please report to your
specialist medical retailer directly. Only
serious incidents which could lead to a
significant deterioration in health or to
death are to be reported to the
manufacturer or the relevant authorities
in the EU member state. The criteria for
serious incidents are defined in
Section 2, No. 65 of the Regulation (EU)
2017/745 (MDR). The traceability of this
product is assured via a UDI code
English
.