Description Of The Unit - ProMed 502 Instrucciones De Empleo

D
esCrIPtIon oF the unIt
Please read the user manual thoroughly before using the appliance for the first time.
Thank you for purchasing the Promed 502 manicure and pedicure unit. This device was
especially designed and manufactured to ensure the quality of treatment and may be used by
both qualified personnel and private individuals after reading these instructions. This unit is
only suitable for use with manicures and gentle pedicures (e.g., removal of thickened skin and
calluses, cuticle care, nail care, treatment of thickened nails, etc.). We, as the manufacturer,
cannot be made liable in any way for injury or damages to people or objects that arise
from failure to comply with this warning. The unit is also suitable for use in the area of nail
techniques and nail design as well as the handling of all materials used in this area such as
gel and acrylic.
We wish you a lot of enjoyment with your new Promed 502 unit. We would like to familiarize
you with the unit in the following sections. Please read the user manual thoroughly before using
the unit for the first time.
I
nFormatIon on the unIt
Before operating the unit for the first time, please check that all contents have been delivered and
that the line voltage is correct. The supplied power adapter (A) is an electronic power supply
unit intended for an operating voltage of 100 V~ to 240 V~. Should you require a different
plug type for the operation of the device, you can purchase it from Promed. To change the
plug type, press the release (I) and pull the power plug (J) from the power supply unit (A). Take
the required power plug (J) and push it back into the power supply unit (A).
• The Promed 502 unit, in combination with the grinding heads designed for this unit, is
ideal for manicures and gentle pedicures, and is also particularly suitable for use with nail
techniques (nail design).
• The Promed 502 unit uses a high performance motor. The electronic speed control is
used to smoothly set the speed of the grinding head. The unit can rotate clockwise or
counterclockwise (reversible).
• The grinding head holder is able to fixate all commercial grinding heads with standardized
dental size shafts of (ø 2.332 to 2.350 mm / 0.091 - 0.093 inches). Please use only high-
quality grinding heads with a rounded shaft end and a maximal shaft length of 36 mm
(1.26 inches) to guarantee the longest life possible for the grinding head holder!
• Always make sure that the grinding head does not come in contact with other objects
when you lay the handpiece down. There is a risk of the shaft becoming compressed and
asymmetrical. Asymmetry in the grinding head causes damage to the handpiece!
• Grinding head bits are available at your local specialist retailer or Promed (www.promed.de).
• To ensure hygienic operation, the grinding heads must be disinfected after use.
• The handpiece may only be disinfected by using a wipe desinfection.
• Information about suitable disinfectants and products can be obtained from Promed.
For disinfection of instruments and grinding heads:
Promed Pure ID (Product No. 330810)
Please keep this user manual in a safe place!
/
aCCessorIes
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI