NORAUTO N1200 Manual De Instrucciones página 113

4. Ensure the ON/OFF switch of the portable jump starter is in the OFF position.
5. Check the polarity of the battery terminals. A positive battery terminal (POS, P, +)
generally has a larger diameter than that of a negative battery terminal (NEG, N, -).
6. Follow the manufacturer's instructions to remove all the isolating covers from the battery
terminals.
7. Connect the positive (+) red clamp to the positive terminal of the vehicle's battery.
8. Connect the negative (–) black clamp to the chassis or to a solid, fixed metal component
of the vehicle or to a part of the chassis. Never connect the clamp directly to the
battery's negative terminal or to a moving part.
9. Warning! If the connections to the battery's positive and negative terminals are incorrect,
the LCD screen will display the Battery Status Icon, Battery Voltage Indicator, and the
Clamp Icons. The Alarm Icon, the "+" and "–" signs and the Reverse Polarity Icons will
flash and an audible alarm will be emitted until the clamps are properly connected.
10. Once the clamps are properly connected, set the portable jump starter's ON/OFF switch
to the ON position.
11. Switch on the car's ignition and start the engine with impulses lasting 3 to 6 seconds.
IMPORTANT : If the engine doesn't start up within 6 seconds, let the device's internal
battery cool down for 3 minutes before trying again.
12. When the vehicle starts up, set the booster's ON/OFF switch to the OFF position.
13. Disconnect the negative (–) clamp from the engine or the chassis first, followed by the
positive (+) clamp.
If the engine does not start after several tries, it is recommended to contact a professional
mechanic; causes may be varied and independent from the state of the battery.
USING THE USB PORTS
1. Press the USB port's power button to turn it on. You will hear a beep
and the LCD screen will display the following:
2. Lift the hood of the USB charging ports.
3. Connect a device that can be powered via USB to the USB charging ports and use it
normally.
4. To turn off the USB function, press the USB power button again, the screen will then stop
displaying the "USB" icon.
Ensure that the USB port's power button is in the "OFF" position when the unit is being
charged or stored.
NOTE
The USB charging port of this unit does not allow data transfer. It can only provide a
5V/2.1A power supply to an external device that can be powered via USB.
Some household appliances powered by USB may not work on this unit.
In a fault condition (low battery voltage fault, overload and short circuit) exists in either of the
USB ports.The Fault Icon will flash.The USB Ports will automatically shut down. Should this
occur:
- Disconnect the USB-powered device and press the USB Power Button again to turn off the
USB Ports immediately.
- Make sure the unit does not need to be recharged.
- Allow the unit to cool down for several minutes before attempting to use the USB Ports
again.
- If a fault occurs again, make sure that the total draw of the USB device plugged into the
USB Ports does not exceed 2.1A.
- If an individual USB device is within specifications and the fault occurs, have the USB
device checked for malfunction and do not continue to use it with these USB Ports.
USING THE 12V DC SOCKET (cigarette lighter)
1. Lift the cover of the device's 12V DC socket.
2. Insert the 12V DC plug of the device you want to charge/use into the socket for 12V DC
accessories. Never surpass 5A of power.
3. Turn on the device, it will operate normally.
4. Periodically check the battery charge status.
USING THE ADJUSTABLE LED LAMP
1. Turn on or off by pressing the LED power button at control panel.
2. The adjustable LED lamp must always be turned off during recharge and when the
product is stored away.
112