Care And Maintenance; Troubleshooting - NORAUTO N1200 Manual De Instrucciones

7. Press the mini compressor's power button again to activate it.
8. Check the actual pressure on the LCD screen.
- When desired pre-set pressure is reached, the compressor will automatically stop.
- Press the Compressor Power Button again to turn off the unit.
- Unscrew and remove the nozzle from the valve stem.
9. Let the product cool down before storing it.

CARE AND MAINTENANCE

Unplug the device before performing maintenance or cleaning it.
After each use, clean the battery clamps so as to avoid rust formation.
Clean the charger's external housing with a soft or microfiber cloth. Do not immerse the
device in water.
Store the cables and clamps in their housing properly.

TROUBLESHOOTING

Problem
Unit will not Make sure all of the unit's functions are turned off.
charge. Make sure the AC charging Adapter is properly connected to both the
DC charging port of unit and a functioning AC outlet.
Make sure the unit is not being operated in the Compressor mode.
Unit fails to
Make sure unit's jump-starter power switch is in the on position.
jump-start.
Make sure a proper polarity cable connection has been established.
Check that unit has a full charge. Recharge unit if necessary.
Make sure the the appliance does not draw more than 5 amps.
12 volt DC
Check that unit has a full charge. Recharge unit if necessary.
accessory outlet
will not power
appliance.
Make sure the USB Power Button has been pressed to turn the USB
USB power port
Ports on.
will not power
If a fault condition exists in any of the USB Ports, the Fault Icon on the
appliance.
LCD screen will flash. Refer to the Important Notes in the "USB Ports"
section to remedy any faults.
Make sure that the total draw the USB device plugged into the USB
Ports does not exceed 2.1A.
Some USB-powered household electronics will not operate with this
USB charging/power port. Check the manual of the corresponding
electronic device to confirm that it can be used with this type of USB
charging/power port.
Check that unit has a full charge. Recharge unit if necessary.
Make sure the area light power button has been pressed to turn the
LED area light
area light on.
does not come
Check that unit has a full charge. Recharge unit if necessary.
on.
Make sure the unit is not being operated in the Jump Starter mode.
Portable
Make sure the compressor power button has been pressed to turn
compressor will
the compressor on.
not inflate.
Make sure the nozzle connector is securely screwed on to the valve
stem when attempting to inflate tires; or that the nozzle adapter is
securely screwed into the nozzle connector and is inserted properly
into the item to be inflated on all other inflatables.
The compressor may be overheated. Press the compressor power
button to turn the compressor off. Restart after a cooling down period
of approximately 30 minutes.
Check that unit has a full charge. Recharge unit if necessary.
Possible Solution
114