Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing lamps
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Replace the old light bulb with the one of the same type as
specified in the feature label or near the light lamp on the
hood.
To replace the damaged fluorescent lamps you must unplug
the product from the mains, then open the panel by following
the instructions in the chapter "PANEL OPENING".
Remove the six perimeter screws of the panel and open it as
shown in figure 11; proceed in replacing the fluorescent lamp
using a lamp with the same characteristics.
Put back into position the panel and the screws you previously
removed.
For the replacement of the fluorescent lamps feeder, act in the
same way as described above, since the feeder is positioned
next to the lamps.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
16
Publicidad
