Publicidad
Idiomas disponibles
Idiomas disponibles
5. With flat head screws and serrated flange nuts, fasten Pivot
Block to Slide Mount. Torque screws with 5mm Hex Driver
to 20 Nm (14.5 in-lbs). Important: Do not over tighten.
FIGURE 5
6. With Slide Mount knob still loose and Rack assembly in the
upside down position, position Rack assembly in Pivot
Block. Insert Knob and Flat Washer as shown. Important:
presence of washer is necessary to ensure proper function
of Knob when tightened.
FIGURE 6
7. With Rack assembly and Pivot securely mated, thread Pivot
Knob into threaded insert. Make certain that the fasteners
are aligned and square to one another to avoid any cross
threading.
FIGURE 7
Back Rack/Divider and Overhead Rack
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
REVISION
AUTH
Using the Back Rack / Divider and Overhead Rack
IMPORTANT: To avoid scuffi ng, small knob on slide mount
assembly MUST be tightened before the accessory is pivoted
into alternate position.
FIGURE 8
BACK RACK /
OVERHEAD RACK
POSITION
DIVIDER
POSITION
Remove top cap with T20 Torx driver to gain access to T-slot in
top rail. Note: Some T-nuts can drop into T-slot without removal
of top cap. IMPORTANT: Top caps MUST be reinstalled before
use.
FIGURE 9
PART NO.
IR 28JN07
INSTALLATION INSTRUCTIONS
DR
TITLE
Back Rack/Divider and Overhead Rack
PART NO.
19169818
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19169818
SHEET
2
SHEET
2
9
OF
9
OF
Publicidad
