ADDITIONAL SAFETY
POINTS FOR YOUR PLANER
1. Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
2. When an extension cable is required you
must ensure it has the correct ampere
rating for your power tool and is in a
safe electrical condition. Fully unwind
cable drum extensions to avoid potential
overheating.
3. Ensure your mains supply voltage is the
same as indicated on the rating plate.
4. Your tool is double insulated for additional
protection against a possible electrical
insulation failure within the tool.
5. Always check walls, floors and ceilings to
avoid hidden power cables and pipes.
6. After long working period's external metal
parts and accessories could be hot.
7. Wear eye protection when operating this
tool.
8. The base plate must always be held firmly
against the material being cut to reduce
vibration and blade jumping.
9. If possible, ensure the workpiece is firmly
clamped to prevent movement.
08
10.Your Planer is a hand held tool; do not
clamp your planer.
11. Before cutting, check the cutting line is free
of nails, screws, etc.
12.Never stop the cutting blade by applying
pressure to the blade.
13.Only withdraw the planer from the cut
when the blade has stopped moving.
14.Only use blades in excellent cutting
condition.
15.Do not put your fingers into the sawdust
dust extraction. Use a wooden stick to
unblock any material.
16.Wait for the cutter to stop before setting the
tool down, an exposed cutter may engage
the surface leading to possible loss of
control and serious injury.
17 . Always wear a dust mask.
18.Hold tool by insulated gripping
surfaces when performing an
operation where the cutting tool may
contact hidden wiring. Contact with
a'live'wire with also make exposed metal
parts of the tool'live'and shock the operator
condition.
Planer
13L-WU621-M-070305¸ÄFÓïCE´¦.indd 8
SYMBOLS
Read the manual
Warning
Wear eye protection
Double insulation
Wear ear protection
Wear dust mask
ENG
3/5/2007 4:17:13 PM