CREE LIGHTING FLX Serie Instrucciones De Instalación página 2

TO INSTALL:
1
Luminaire Hooks
2
Cable Slots
Power Supply
Junction Box Cover
3
2 of 4
T-bar
Dimming Leads
Junction Box Cover
1st:
T- BAR CEILING MOUNTING
90° Bend
STEP 1:
Bring the FLX troffer up into the T-Bar
grid.
STEP 2:
Locate the luminaire hooks and bend
them out 90 degrees for installation. See
Figure 1.
NOTE: The luminaire hooks ship bent in
and need to be bent out for installation.
2nd: Bend
STEP 3:
Against T-bar
Then bend the luminaire hooks against
the T-Bar to secure the luminaire. See
Figure 1.
SUSPENDED MOUNTING
STEP 1:
T-bar
Attach customer supplied cables to
the (2) cable slots on each side of the
housing. See Figure 2.
STEP 2:
Attach customer supplied cables to
mounting surface using customer
supplied hardware. Ensuring that
mounting surface can support the
luminaire.
0 - 10V SETUP
OPTION: Power whip (if installed) skip
Steps 1-3 and refer directly to the
Electrical Connections section and wire
flying leads.
NOTE: Power whip is not supported for
-GTD options.
STEP 1:
Remove the cover of the power supply
junction box and bring conduit into the
power supply compartment using one of
the provided knock-outs. See Figure 3.
STEP 2:
Remove the cover of the dimming
junction box and bring dimming conduit
into dimming wire compartment using
one of the provided knock-outs. See
Figure 3.
STEP 3:
Wire luminaire per "Electrical
Connections" section and push all leads
into the junction box. Reattach junction
box cover that was removed in Step 1 ,
make sure no wires are pinched.
Optional Power
Whip
(if installed)
LPN000437X0005A0_A