Nose Mask; Cleaning; Cleaning The Parts - Silvercrest SGS 100 A1 Instrucciones De Servicio

BB*5$B*HVLFKWVVDXQDB%ERRN 6HLWH  'RQQHUVWDJ  -XOL    
5. Switch the on/off switch/steam flow
rate controller 7 to 0. The LED 8 extin-
guishes and the device is switched off.
6. Wait for the device to completely cool
down.
7. Pull out the mains plug 10.
8. By a slight turn to the right you release
the face mask 1 and take it off.
9. If necessary, you take off the lid of the
aroma reservoir 3 and dispose of the
content of the aroma reservoir.

7.4 Nose mask

DANGER! Hazard caused by
hot steam!
~ Figure B: the distance to the water
container is significantly less during use
of the nose mask 2 and the steam effect
is significantly higher. Therefore, the
nose mask 2 may only be used with
stage I.
1. Prepare the nose mask as described
(see "Assembly" on page 42).
2. Switch the on/off switch/steam flow
rate controller 7 to I. The LED 8 lights
up.
3. Figure D: after approx. 2-3 minutes,
steam is generated. Hold your nose
into the nose mask 2. Close your eyes
and enjoy the beneficial effect of the
steam.
NOTE: the closer you place your nose to the
nose mask 2, the more intensive the effect of
the steam on the nasal mucosa will be. If this
becomes too much for you, take your nose a
little out of the nose mask 2.
4. Switch the on/off switch/steam flow
rate controller 7 to 0. The LED 8 extin-
guishes and the device is switched off.
5. Wait for the device to completely cool
down.
44 GB
6. Pull out the mains plug 10.
7. Pull off the nose mask 2 from the aro-
ma reservoir 4.
8. By a slight turn to the right you release
the aroma reservoir 4 and take it off.
9. If necessary, you take off the lid 3 of
the aroma reservoir 4 and dispose of
the content of the aroma reservoir.

8. Cleaning

DANGER!
~ Pull out the mains plug 10 from the wall
socket before cleaning the facial sauna.
~ Allow the device to cool down com-
pletely before you transport or clean it.
~ Allow all parts to cool down before re-
moving them from the device.
WARNING! Risk of material damage!
~ Do not use any astringent or abrasive
cleaning agents.
Clean the device and the parts used after
every use.
• Wipe off the basic unit 6, using a light-
ly moistened cloth.
• Wipe the water container 5 with a
damp cloth and dry it.

Cleaning the parts

1. All accessory parts used such as face
mask 1, nose mask 2, aroma reservoir
4 and the lid 3 of the aroma reservoir
need to be cleaned with warm soap
water.
2. Rinse off with clear water.
3. Dry off all accessory parts.