Publicidad
2) Use the key [UP] to choose [F6].
3) Press the key [ENT], the registered minimum number appears.
4) Use the key [UP], [MOVE], or [DOWN] to choose the number to be deleted.
5) Press the key [ENT], delete the number when it flashes with sounds. Then the next
registered number appears on the screen.
If initialization is needed, press the key [ENT], the numbers keep changing on the screen.
When [00]、[000]or[000-00] appears, the initializing is completed.
6) Press the key [ESC] and [F6] appears
7) Press the key [ESC] once more, back to standby mode, the number deleting is done.
※Special functions
◆Number display mode setting( all-digital display or digits beginning with an English letter)
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Use the key [UP] to choose [F8].
3) Press the key [ENT] and [01] appears.
4) Use the key [UP], [MOVE], or [DOWN] to choose a number. 01~10 is all-digital display
(default setting), and 11~20 is digits beginning with an English letter ( A,B,C,D,E,F,H,P,J or L)
display.
5) Press the key [ENT] and [F8] appears on the screen.
6) Press the key [ESC], back to standby mode.
Cautions:
1. Please keep the wireless calling products away from the below interference sources
1) Base stations of mobile equipment.
2) Refrigerators、air conditioners and other high-powered electric appliances.
3) Large ultrasonic equipment in hospitals.
2. Installation notes
1) Plug in the adapter first (no wet hands) and connect with the receiver after power light on.
Then, turn on the receiver.
2) Any abnormality founded, please contact with SINGCALL customer service. To avoid
unnecessary troubles, please don't disassemble the products by yourself.
3) It is recommended to use original accessories.
4) The pagers needed to be registered to the receiver before use. Keep the call buttons at
least 30cm away from the receiver and make sure no one else presses the call buttons during the
registration. It is normal if one or two pagers can not be registered successfully when so many
pagers are registered at a time. Register the failed ones again. Check the receiving distance
before fixing the registered pagers.
5) Draw out the antenna of the registered receiver before use.
6) Please adjust the frequency of the walkie-talkie out of the range 433.92±10MHZ to avoid
disturbance if the wireless calling system and the walkie-talkie are using in the same place.
7) Please keep dry to avoid circuit oxidation.
8) The weather (Weather conditions will influence) influences the receive distance.
7
Publicidad
