Operation And Maintenance; Important; On Mode And General Settings; Lighting - Astralpool DANCER JET Manual De Instalación, Operación Y Mantenimiento

[en]
Fountain units
3

OPERATION AND MAINTENANCE

IMPORTANT: Protect the water outlet from the wind and do not operate the unit in strong wind.
If the unit is installed in an area frequently exposed to strong wind, it is possible that the wind
will displace the water outlet.
3.1

ON MODE AND GENERAL SETTINGS

The unit is switched on and controlled (movement, lighting, jet nozzle height) from the
-
fountain's general control panel, which is not included with this unit (see chapter 2.2).
The shaft's angle of movement can be restricted using the two stoppers on the guide bar
-
on the motor of the main shaft (④, Halospots only).
3.2

LIGHTING

The lighting does not form part of this unit. See the documentation of the lighting installed.
3.3

MAINTENANCE

For the maintenance of the components made of stainless steel, see the manual attached.
It is recommended that the unit be run in maintenance mode once a month to check that the
shaft is working properly.
Check the state of repair of the mechanical seal two years after installation. Once this time has
elapsed, complete this check every three months.
4

TECHNICAL SPECIFICATIONS

Input voltage
Jet nozzle diameter
Power load (without lighting)
Water inlet connection
IP protection rating (IEC 60529)
5

FAQS

Question
Why isn't the water coming out of the jet
nozzle properly? (speed, height)
Why isn't the unit moving?
20
Answer
Check the pump is working properly.
Check the inside of the nozzle. It should free
of all deposits and blockages.
Check the control panel is properly
assembled.
Check that the unit has not been disabled by
a programmed timer.
Installation, operation and maintenance manual; Dancer jet
230 V AC
16/20 mm
160 W
1-½" G
IP68