GB
Troubleshooting
Problem
Possible cause
Solution
Pressure incorrect
Set the correct air pressure according to the specification
Dirt within the mechanism
Pour oil into air inlet as per maintenance instructions
Tool operating slowly
Air blockage
Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by re-tightening, using
Air leak
PTFE tape or replacing
Dirt or rust in mechanism
See 'Tool operating slowly' solutions
Tool seized
Dirt or rust in mechanism
Tap tool gently with a soft mallet
Dirt or rust in mechanism
Free mechanism by rotating drive manually when disconnected from air line
Accessory fitted incorrectly
Remove accessory, inspect for damage and refit
Strong vibrations when tool is
Accessory damaged (cracks, deformations or splinters)
Replace cutting accessory
switched on
Spindle bent
Have the tool repaired by an authorised Silverline service centre
Tool will not stop after trigger is
Throttle valve O-ring or valve seat damaged
Have the tool repaired at an authorised Silverline service centre
fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
8