Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
IT
TECHNICAL
CHARACTERISTICS
Voltage ..................................See data plate
Motors power ...................................1900 W
Sound level ....................................65 dB(A)
Depression ....................................190 mbar
Useful capacity tank ............................... 56 l
Detergent tank capacity ......................... 11 l
Dimensions ...............610 x 540 x 920H mm
Weight .............................................. 24,5 kg
Accessories ................................... Ø 40 mm
TYPE OF USE
This appliance was designed for spray wash-
ing and extracting any type of fabric, carpet,
car seats, floors etc.
It can be used as a vacuum cleaner and or
solid and liquid suction unit with the appropri-
ate accessories upon request.
It has only been designed for these uses.
DANGER:
The manufacturer can not be held respon-
sible for any damage due to improper or
incorrect use.
Any other use releases the manufacturer
from liability for harm to persons and/or
property and invalidates any warranty
condition.
IMPROPER USE
Do not use the appliance to:
-
Aspirate flammable, explosive, corrosive
and toxic substances.
-
Aspirate hot substances.
-
Do not use the appliance in liquid suction
mode to suction powder and vice versa.
Do not use the appliance in areas at risk of
explosion.
PREPARING THE
APPLIANCE
Assembling the hoses
-
Insert, as far as possible, the sleeve (1
Fig. 1) of the suction hose into the nozzle
(2 Fig. 1) on the drum.
-
To release the sleeve (1 Fig 2) press and
hold the button (3 Fig 2) and then pull out
the sleeve (1 Fig 2).
-
Connect the (4 Fig. 3) detergent delivery
hose to the quick coupling (5 Fig.3); to re-
lease it push the quick coupling (5 Fig.3)
inwards.
-
Check that the suction pipe cleaner (6
Fig. 4) is properly connected to the tank
(7 Fig. 4).
Rigid pipe assembly for washing carpets
or floors (if present)
After connecting the suction hose to the out-
let the drum, do as follows:
-
Remove the hose from its stiff as follows:
- Top Tube (8 Fig. 5).
- Lower Hose (9 Fig. 5) complete with
pipe cleaner and nozzle.
- Nozzle for carpets and floor coverings
(10 Fig 5).
-
Hook the two rigid extensions (8 and 9
Fig 6), matching the two references (11
Fig 6)
-
Connect the hose (12 Fig 7) coming from
the nozzle quick connector (13 Fig.7) of
the dispenser lever; push the lever.to re-
lease, the quick connector (13 Fig.7.
-
Insert the floor nozzle (10 Fig.8) into the
tube (9 Fig.8).
-
Placethe nozzle (14 Fig 9) on the mouth-
piece (10 Fig 9) hooking it into the appro-
priate bumps in the nozzle (10 Fig 9).
-
Insert the tube (8 Fig. 10) in the hose (15
Fig 10)
-
Connect the quick connector (16 Fig 11)
of the supply pipe to the fitting (17 Fig 11)
of the dispensing; to release the quick
connector (16 Fig.11) push lever to the
outside of the tube.
EN - 6
Publicidad
Tabla de contenido
