Operating Tips - sunjoe 24V-X2-CS16 Manual Del Operador

4. To turn the tool on, hold the chain saw firmly with both
hands on the handles. Press the safety lock button,
then squeeze the trigger switch. When the chain saw is
running, you can release the safety lock button (Fig. 11).
Fig. 11
5. To turn the tool off, simply release the trigger switch.
NOTE: Do not squeeze the trigger switch until you are
ready to make a cut.
Working Load Indicator
The machine is equipped with an working load indication
system located behind the front hand brake (Fig. 12), which will
be illuminated immediately when battery is installed. Consult to
the table below for the indication of the working status of the
chain saw.
Fig. 12
Lights Light Indicators
Yellow The saw is ready to make a cut
Green The saw is working properly
The saw is overloaded. Stop working
Red immediately; Otherwise the circuit is going to
cut off automatically in 2 seconds
NOTE: If an overload situation happens and the machine
cuts off automatically, switch the machine off and remove the
batteries. Let the machine and batteries cool down for a while
before resuming work.
Safety lock
button
Trigger switch
Working load
indicator

Operating Tips

m
WARNING!
For your safety and that of others:
1. Do not use the machine without reading the instructions
carefully. Become acquainted with the controls and
the proper use of the machine. Learn how to stop the
machine quickly.
2. Keep in mind that the operator or user is responsible
for accidents or hazards occurring to other people or
their property.
3. Always wear suitable clothing when using the machine.
Wear anti-vibration gloves and other personal
protective equipment.
All the above-mentioned precautions do not, however,
guarantee the prevention of certain risks – i.e. Raynaud's
phenomenon or Carpal tunnel syndrome. For operators
who use this machine for prolonged periods, it is
therefore recommended to have periodic checkups
on their hands and fingers. If any of the above
mentioned symptoms should appear, please contact a
physician immediately.
4. Work only in daylight or good artificial light.
5. Take utmost care when working near metal fences.
6. Take care not to hit the bar hard against foreign objects or
flying debris caused by the movement of the chain.
7. Stop the motor and remove the batteries from
the compartment:
– Whenever you leave the machine unattended;
– Before cleaning, checking or servicing the machine;
– After striking a foreign object. Inspect the machine
for any damage and make repairs before restarting
it again;
– If the machine begins to vibrate abnormally,
immediately look for the cause of the vibrations
and have the machine inspected at an authorized
Snow Joe + Sun Joe
®
+ Sun Joe customer service center at
®
1-866-SNOWJOE (1-866-766-9563) for assistance;
– When the machine is not in use.
IMPORTANT! Always remember that an incorrectly used
chain saw may disturb others and have a serious impact on
the environment.
To respect people and the environment:
• Avoid using the machine in environments or at times of the
day when it may disturb others.
• Scrupulously comply with local regulations and provisions
for the disposal of waste materials after sawing.
• Scrupulously comply with local regulations and provisions
for the disposal of oils, damaged parts or any elements
which have a strong impact on the environment.
• A certain amount of chain lubricating oil is released into
the environment when the machine is running, so only use
biodegradable oils made specifically for this use.
12
dealer or call the Snow Joe
® ®