Step-By-Step Instructions; Hygiene; Manual Cleaning And Disinfection - DENTSPLY Compules Tips Gun Manual Del Usuario

3

Step-by-step instructions

3.1 Application
1. Insert Compules
certain that the collar on the Compules
2. Remove the colored cap from the Compules
tated 360° to gain the proper angle of entrance into the cavity or to the mixing pad.
DO NOT USE EXCESSIVE FORCE.
Dispense the material directly into the cavity preparation using a slow, steady pres-
sure.
3. To remove the used Compules
pulled back completely by allowing the handle to open to its widest position. Apply
a downward motion to the front end of the Compules
Excessive force.
Injury.
1. Apply slow and steady pressure on the Compules
2. Do not use excessive force. Compules
For further information please refer to composite Instruction for Use.
4

Hygiene

NOTICE
Wrong cleaning or disinfection method.
Damage to the device.
1. Always disassemble Compules
2. Do not clean or disinfect with aggressive agents (e.g. solutions based on orange
oil or acetone).
4.1 Disassembly and preparation for reprocessing
1. Partially close the Compules
hinge.
2. Push upwards and lift hinge. The Compules
and the plunger is exposed.
3. In case of gross contamination of the Compules
brush and running water.
4. Remove restorative material, if any, with a soft paper tissue and alcohol of 70% vol.

4.2 Manual cleaning and disinfection

1. Discard gloves according to local regulations.
2. Disinfect hands with an appropriate bactericidal, virucidal, and fungicidal hand dis-
infectant solution according to local regulations. Use according to disinfectant solu-
tion manufacturer's Instructions for Use.
3. Use a new clean pair of examination gloves.
4. Clean Compules
cleaning solution until free of visible contamination. Pay special attention to device
seams and insertions.
5. Remove cleaning solution residue with a cloth soaked with water.
Tip into the notched opening of the Compules
®
®
Compules Tips Gun may result.
®
Tips Gun and place your thumb on the rear part of the
®
Tips Gun with a soft brush, warm water, and an appropriate
®
Tip is inserted first.
®
Tip. The Compules
®
Tip, be sure that the Compules
Tips Gun before reprocessing.
®
Tips Gun is separated into two parts
®
Tips Gun, remove it using a soft
®
Tips Gun. Be
®
Tip may be ro-
®
Tips Gun plunger is
®
Tip and remove.
®
Tips Gun.
®
Tip rupture or ejection from
®
3