Makita HHU01 Manual De Instrucciones página 7

Low battery voltage:
•
The remaining battery capacity is too low
and the tool will not operate. In this situation,
remove and recharge the battery.
Battery remaining capacity indicator
(only for models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light
for approx. three seconds.
Indicator lamps
Lighted Off Blinking
E
011713
When only the lowermost indicator lamp (next to the
•
"E") blinks, or when none of the indicator lamps light,
the battery capacity has run out, so the tool does
not operate. In these cases, charge the battery or
replace the empty battery with a fully charged one.
When two or more indicator lamps do not light
•
even after charging is complete, the battery has
reached the end of its service life.
When the upper two and lower two indicator lamps
•
light alternately, the battery may have malfunctioned.
Contact your local Makita authorized service center.
NOTE:
The indicated capacity may be lower than the actual
•
level during use or immediately after using the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
1. Indicator lamps
2. CHECK button
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
OPERATION
CAUTION:
Be careful not to accidentally contact a metal
•
fence or other hard objects while trimming. The
blade will break and may cause serious injury.
Overreaching with a hedge trimmer, particularly
•
from a ladder, is extremely dangerous. Do not
work from anything wobbly or infirm.
007559
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
CAUTION:
Do not cut off dead trees or similar hard objects.
•
Failure to do so may damage the tool.
011151
Hold the trimmer with both hands and pull the switch
trigger A or B and then move it in front of your body.
1
2
011262
As a basic operation, tilt the blades towards the
trimming direction and move it calmly and slowly at the
speed rate of 3 - 4 seconds per meter.
7
1. Trimming
direction
2. Hedge surface
to be trimmed
3. Tilt the blades.
3