Makita HHU01 Manual De Instrucciones página 8

1
011153
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
011154
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
011263
Rotate the handle for your easy handling before
operation. Refer to the section titled "Handle mounting
position"
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
011156
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
1. String
8
Installing or removing chip receiver
(accessory)
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing chip receiver.
NOTE:
When replacing the chip receiver, always wear
•
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
Always be sure to remove the blade cover before
•
installing the chip receiver.
The chip receiver receives cut-off leaves and
•
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
1
3
4
009290
Press the chip receiver on the shear blades so that its
slits overlap with the nuts on the shear blades. At this
time, make sure that the chip receiver does not contact
branch catcher at the top of the shear blades.
1
009291
At this time, the chip receiver needs to be installed so
that its hooks fit into grooves in the shear blade unit.
2
3
009292
To remove the chip receiver, press its lever on both
sides so that the hooks are unlocked.
1. Press
2
2. Chip receiver
3. Nut
4. Shear blade
1. Nut
2. Branch catcher
2
1. Hooks
1
2. Fit the hooks
into groove
3. Grooves