Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000143-002.book Page 10 Wednesday, May 11, 2016 10:46 AM
10 Spring plate
11 Clamping surface
12 On/Off switch
Not all of the accessories illustrated or described
are included as standard delivery.
Tool Specifications
Sheet metal shears
Article number
0702 713 X 0702 714 X
Rated power input
Output
Stroke rate at no-load
3900 rpm
Max. workpiece thick-
ness
– Steel sheet
2
(400 N/mm
)
– Stainless steel sheet
2
(600 N/mm
)
– Stainless steel sheet
2
(800 N/mm
)
– Non-ferrous steel
sheet
2
(250 N/mm
)
Cutting radius
sheet thick-
Weight
Class of protection
Initial Operation
Observe the mains voltage! The voltage of
the power source must correspond with the data on
the type plate of the machine.
Switching On and Off
Switching on:
Push the switch toward the front.
Switching off:
Push the switch toward the rear.
Before any work on the machine itself,
Wear safety glasses/goggles.
Replacing the Cutting Blade
Clamp the power tool by the clamping surfaces 11 in
EB 13-2
EB 20-2
a vice between aluminium protection jaws.
Before replacing the cutting blade, apply
300 W
500 W
180 W
300 W
2200 rpm
Unscrew the screws 13 and remove the spring plate
10. Remove the spring 14.
Remove the circlip ring 9 and the washer 7. Press the
blade bolt 8 back.
1.3 mm
2.0 mm
Lift out the blade 5 and remove it toward the front.
1.0 mm
1.5 mm
Do not interchange the spacers 15: Incor-
1.0 mm
1.3 mm
Insert the new cutting blade with the old spacers 15.
Insert the blade bolt 8. Mount washer 7 and the circlip
2.0 mm
3.0 mm
ring 9.
145 mm
215 mm
Insert the spring 14. Mount the spring plate 10 and the
(1.3 mm
support roller.
ness)
Replacing Cutting Bars
1.6 kg
1.8 kg
Loosen screws 18 and remove the cutting bars 6. Push
II
II
the alignment pins 17 out. Mount new cutting bars with
the alignment pins. tighten the screws 18 again.
Adjusting the Blade Clearance
When the clearance between the cutting blade and the
cutting bars is too large, loosen cap screw 4. Adjust the
clearance with set screw 3. Tighten cap screw 4 again.
The cutting blade may not graze against
Note: When a large burr forms during cutting, repeat
the adjusting procedure.
Sharpening the Cutting Blade/
Cutting Bars
The cutting blade and the cutting bars must be resharp-
ened and readjusted together.
This task should be performed by an authorised cus-
tomer service agent for Würth power tools. Send in the
complete machine for this.
Replacing/Adjusting the Cutting
Blade (see figure A)
pull the mains plug.
a drop of oil each on the left and right
between housing 16 and blade 5.
rect clearance or spacing of the cutting
bars and cutting blade can destroy them.
the cutting bars: Danger of breakage.
10
Publicidad
