Sony ICD-P630F Guia De Inicio Rapido página 23

Connecting the IC recorder
to your computer
You can transfer the IC recorder data
onto your computer by connecting the
IC recorder to the computer.
Use the USB connecting cable supplied
with the IC recorder to connect the USB
connectors of the IC recorder and your
computer.
The IC recorder is recognized by
the computer as soon as the cable
is connected. You can connect or
disconnect the cable when the IC
recorder and the computer are turned
on or off.
To USB
connector of
IC recorder
Connecting cable
(supplied)

Notes
Be sure to install the Digital Voice Editor

software before connecting the IC recorder
to your computer. Otherwise, a message like
[Found New Hardware Wizard] may appear
when you connect the IC recorder to your
computer. In this case, click [Cancel].
Do not connect more than two USB devices

to your computer. Normal operation will not
be guaranteed.
Use of this IC recorder with a USB hub or a

USB extension cable is not guaranteed.
A malfunction may occur depending on the

USB devices connected at any one time.
Before connecting the IC recorder to the

computer, check that batteries are inserted
in the IC recorder.
When you connect the IC recorder to the

computer, make sure that the IC recorder is
in the stop mode.
It is recommended that you disconnect the

cable from the computer when you do not
use the Digital Voice Editor.
To USB
connector
of your
computer

GB