Team kalorik TKG CMM 1000 Manual De Instrucciones página 10

Fax +32 2 359 95 50
The appliance is designed for the preparation of small quantities of food that have to be
consumed rather quickly. It is not designed for the preparation of large quantities at once.
Never touch the blade when the appliance is in use. Furthermore, never try to stop the
movement of the blade in any way whatsoever.
We recommend that when using your product you operate the motor unit in short on/off
pulses. This will give better chopping, mixing, etc. It will also ensure that long-lasting
performance from your motor. Please refer to the information at the end of this instruction
booklet for recipe information and operating guidelines.
The chopper is designed to be used exclusively in its delivery state (bowl, lid and blades in
good state) because it gives all the needed securities. Do not try to substitute one of those
pieces by another one and if you have to replace one, contact your after sales service.
Competent qualified electrician: after-sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for long lasting use. You should never exceed the maximum operating
time indicated in the table below (see page 11-12). Failure to follow this instruction carefully
may result in damage to the motor. Please make some operation breaks regularly. The breaks
should last at least 10 minutes.
BEFORE THE FIRST USE
• Remove all packaging, and check that no parts are damaged or missing.
• Read these instructions carefully!
• Wash the bowl, lid, chopper blade and axle unit in warm soapy water and dry thoroughly.
• Wipe the motor unit and lid of the chopper with a damp cloth.
• Rinse the leg under warm running water, wipe the blade with a damp cloth and dry
thoroughly.
• Remove the stainless steel whisk from the whisk body and wash in warm soapy water, wipe
the whisk body with a damp cloth and dry thoroughly.
USING THE STICKMIXER (motor unit and metal leg)
• Ensure that the unit is unplugged.
• Screw the shaft onto the screw thread at the bottom of the motor unit. You should place
the symbol ▼ on the motor unit in front of the opened padlock
screw it to the motor unit, so that the closed padlock
Using gentle hand pressure only ensures that the shaft is fully tightened onto the motor
unit.
• Put the ingredients into the bowl or a suitable container (such as a mixing bowl or pan).
Do not overfill to prevent splashing.
• Plug the unit into a suitable mains socket.
• Hold the unit securely and press the on/off button. We recommend that the motor unit is
operated in short on/off pulses.
• When mixing liquids ensure the blade is fully immersed before switching on the appliance
to prevent splashing.
• Never remove the unit from the liquid until the blade has totally stopped spinning.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
ends up in front of the symbol ▼.
10
Assembly page 10/56
on the shaft and then
TKG CMM 1000 - 100628