Charging The Product - V-TAC VT-5556 Manual De Instrucciones

Charging The Product

Place the Charging Dock on a hard, level surface and
against a wall. Remove objects within 1.5 ft/0.5 m on both
sides and within 3 ft/1 m in front of the Charging Dock.
Plug the adapter into the wall outlet and plug the DC jack into
the DC socket of the Charging Dock.
When the charging dock is connected to AC power, the LED
indicator on the charging dock starts to flash green light.
T
Install the Charging Base in a location that Robot
can easily access. Please place the Charging Base
against a wall, and on a hard-level surface rather
than on rugs or carpets.
- Always keep the Charging Base plugged in,
otherwise Robot will not automatically return to it.
C
Place the laser vacuum on the charging dock for charging
the battery. (When charging, indication light flashes. When
the charging is completed the indication light will stop
flashing and change to constant light. Normal charging time
is about 5 hours)
Robot returns to the Charging Dock at the end of a cleaning
cycle or when its battery is running low
Caution:
Do not expose Charging Dock with direct sunlight or any
strong reflection on light source. If cannot be avoided, please
cover the bottom part of Charging Dock about 7 cm.
Recommend to fully charge the robot to ensure operating
time.
Avoid to have Water Tank inserted in robot when charging.
Avoid to have wet mopping cloth in which may damage
wooden floor.
9