Removal - Wilo TR/E 216 Serie Instrucciones De Instalación Y Funcionamiento

en-US
8.4

Removal

32
Decommissioning/removal
If the mixer remains installed after decommissioning, observe the following:
ƒ
Ensure that the aforementioned requirements are maintained for the complete period of
decommissioning. If these requirements cannot be guaranteed, remove the mixer!
ƒ
For an extended period of decommissioning, carry out a function test at regular intervals:
–
Period: monthly to quarterly
–
Running time: 5 minutes
–
Run a function test in valid operating conditions only!
DANGER
Danger due to fluids which are hazardous to health!
Danger of bacterial infection!
• Disinfect the mixer after removal!
• Observe information from the work regulations!
DANGER
Electrocution hazard!
Improper conduct when carrying out electrical work causes death due to electric shock!
• Electrical work must be carried out by a qualified electrician!
• Observe local regulations!
DANGER
Risk of fatal injury due to dangerous lone working practices!
Working in pump chambers and tight spaces as well as working where there is a danger
of falling is dangerous work. This work must not be carried out alone!
• Only carry out work with another person!
WARNING
Risk of burns due to hot surfaces!
The motor can get hot during operation. This can lead to burns.
• Allow the motor to cool down to ambient temperature after switching it off!
Wear the following protective equipment while performing the work:
ƒ
Safety shoes: Protection class S1 (uvex 1 sport S1)
ƒ
Protective gloves: 4X42C (uvex C500)
ƒ
Wear a safety harness where required!
ƒ
Safety helmet: EN 397 Conforms to standards, protection against lateral deformation
(uvex pheos)
(When using lifting equipment)
If contact with hazardous fluid occurs during work, wear the following additional protective
equipment:
ƒ
Safety goggles: uvex skyguard NT
–
Labelling frame: W 166 34 F CE
–
Labelling disc: 0-0.0* W1 FKN CE
ƒ
Breathing protection: Half mask 3M series 6000 with filter 6055 A2
The protective equipment specified is the minimum requirement. Observe the specifications
of the work regulations!
* Protection level according to EN 170 not relevant for this work.
WILO SE 2021-10