Assembly; Making The Electrical Connection - Home Decorators Collection 59252 Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
3
Setting the code on the remote
control and receiver
NOTE: The frequencies on your receiver and hand unit have
been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and hand unit
are set to the same frequency. The dip switches on the
hand unit are located inside the battery compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage
the hand unit. Dispose of used battery properly and keep
the battery out of the reach of children.
□
Remove the remote control (I) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or
down. The factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (H) to the same
position as set on the remote control (I).
□
Install the 23A 12V battery (included).
□
Replace the battery cover on the remote control (I).
□
Insert the silicone rubber stopper (TT) into the hole on the
receiver (H) to cover the dip switches.
H
ZZ
I
ON
TT
1 2 3 4
4

Making the electrical connection

WARNING: Each wire nut supplied with this fan is designed to
accept up to one 12-gauge house wire and two wires from the
fan. If you have larger than 12-gauge house wiring or more
than one house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.
IMPORTANT: Use the plastic wire connectors (BB) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
□
Spread the wires apart so that the green and whites are
one side of the outlet box and the black wire is on the other
side.
□
Connect the green fan wires to the household ground wire
(this may be a green or bare wire) using a wire connecting
nut (BB).
□
Connect the receiver (H) red or black wire to the household
black (hot) wire using a wire connecting nut (BB).
□
Connect the receiver (H) white wire to the household white
(neutral) wire using a wire connecting nut (BB).
□
Secure each wire connecting nut using electrical tape.
□
Wire the receiver (H) to the fan wires by connecting the
molded adaptor plug from receiver (H) with molded adaptor
of the fan motor assembly (C) together.
H
White
Red or
Black
Black
8
Outlet box
in the ceiling
Green or bare wire
BB
White
C