Precor UBK 665 Referencia Rápida página 8

Check the alignment of the running belt
(treadmill only)
IMPORTANT
Failure to align the belt may cause the belt to tear or fray, which
is not covered by the Precor Limited Warranty.
Proper alignment allows the belt to remain centered and ensures
smooth operation. Realigning the belt takes a few simple
adjustments. If you are unsure about this procedure, contact Precor
Customer Support.
CAUTION
DO NOT adjust the running belt when someone is
standing on it.
To check the alignment of the running belt:
1. Make sure that the running surface is as level as possible. If
necessary, adjust the rear feet to level the treadmill.
NOTE
Adjusting the rear feet cannot compensate for extremely
uneven surfaces. If you cannot make the running surface
level and stable, move the treadmill.
2. Turn the treadmill on.
3. Stand beside the treadmill (not on it), and press GOor Quick
Start on the console.
4. If necessary, enter the safety code by pressing the number keys
in sequence. The running belt starts automatically after a 3-
second countdown appears on the console.
5. Press SPEED UP until the console shows a speed of 3 mph (5
kph).
6. Observe the belt from the rear of the treadmill for a few
minutes. The belt should remain centered along the running
bed. If it drifts off center, you need to adjustment it.
CAUTION
If you hear any rubbing or the running belt appears
damaged, press the red STOP button immediately
and contact Precor Customer Support.
7. Press STOP to stop the belt and turn the treadmill off.
9