Nolan N70-2 GT Seguridad E Instrucciones página 21

- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions (low tem-
peratures, high humidity, sudden changes in temperature or heavy rain) or intense
and prolonged use may affect the performance of the PINLOCK
cause fogging or formation of condensation. In such cases, to restore the sys-
tem efficiency after using the helmet, remove the PINLOCK
helmet visor and let it dry with dry and warm air. The same procedure must be
applied to the helmet, in order to dry out humidity in case it has formed up as a
consequence of the conditions described above.
3 DISASSEMBLING THE PINLOCK
3.1 Remove the visor equipped with the PINLOCK
above).
3.2 Widen the visor and release the PINLOCK
3.3 Release the visor.
4 MAINTENANCE AND CLEANING OF THE PINLOCK
4.1 Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
4.2 Dry the visor with dry and warm air without wiping it.
4.3 To keep the features of the visor in good conditions over time, let the helmet dry
in a ventilated and dry place with the visor open after use. Keep it away from heat
sources and store it in a place away from direct light.
4.4 Do not use solvents or chemical products.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™ (*) polycar-
bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. It is very
simple and practical to use: just lower it to activate it or lift it to remove it from the field
of vision. It is useful in all sorts of situations, both on long journeys out of town and
shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need of any tools for ordinary maintenance and cleaning
operations.
1 VPS OPERATION
The VPS mechanism allows to activate the sunscreen by simply lowering it until it par-
tially covers the visor field of vision. In this way, the desired light transmittance reduc-
tion is achieved.
LEXAN is a trademark of SABIC.
(*)
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
INNER VISOR
®
inner visor from the visor. Using a damp and soft cloth,
®
inner visor to prevent it from
®
inner visor may result in exces-
®
inner visor (see instructions
®
inner visor from the pins (Fig.13).
®
INNER VISOR
®
INSTRUCTIONS FOR USE
N70-2 GT
inner visor and
®
inner visor from the
®
21