Nolan N70-2 GT Seguridad E Instrucciones página 27

1 ASSEMBLING THE PEAK
1.1 Disassemble the visor or the side plates from the helmet (see instructions above).
1.2 Position the left side part of the peak on the corresponding side mechanism cen-
tring the side hole of the peak on the mechanism (Fig.29).
1.3 Push the release lever of the mechanism completely upwards and then push the
peak against the mechanism (Fig.30).
1.4 Disengage the release lever so that it returns downwards, to its initial position.
Then ensure that the peak remains hooked to the mechanism by pulling it out-
wards.
1.5 Follow the previous operations on the right side of the helmet.
WARNING
- Make sure that the mechanisms are working properly. Rotate the peak upwards or
downwards ensuring that the mechanisms hold it in the two different positions. If
necessary, repeat the above-mentioned operations.
- Do not force the peak beyond its end-stop positions: this could damage the peak
or the side mechanisms.
- Do not use the helmet if the peak has not been assembled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorized dealer.
2 DISASSEMBLING THE PEAK
2.1 Adjust the peak to the maximum height position thereof (Fig.28).
2.2 Push the release lever of the left side mechanism completely upwards (Fig.30)
and, then move the peak away from the helmet.
2.3 Disengage the release lever so that it returns downwards, to its initial position.
2.4 Follow the previous operations on the right side of the helmet.
WARNING
- When using the helmet without the visor and without the peak, assemble the side
plates always.
- Do not remove the side mechanisms from the shell.
WIND PROTECTOR
(Available as standard or accessory/spare part)
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig.31 for assembly and disassembly operations.
N70-2 GT
INSTRUCTIONS FOR USE
27