Optional Accessories; Protecting The Environment - DeWalt D25899 Traducido De Las Instrucciones Originales

MAINTENANCE
Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
This machine is not user-serviceable. Take the
tool to an authorised D WALT repair agent after
e
approximately 100 hours of use. If problems occur
before this time contact an authorised D
repair agent.
Accessory Maintenance (fig. 9)
Accessory maintenance at the right time guarantees
optimal results in application and a long and efficient
accessory life.
Grind the chisels on grinding discs. Refer to Figure 9
for the appropriate angles of the following chisels:
j. spade-shaped chisel
k. cold chisel
l. pointed chisel
m. U-shaped chisel
n. hollow chisel
o. mortar chisel
p. toothed chisel
WARNING: These chisels can be
reground only a limited number of
times. If in doubt, contact your dealer
for recommendations.
WARNING: Ensure that the cutting
edge does not show discolouration
caused by too much pressure. This may
impair the hardness of the accessory.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WALT
e

Optional Accessories

Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Should you find one day that your D
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
WARNING: Blow dirt and dust out of
the main housing with dry air as often
as dirt is seen collecting in and around
the air vents. Wear eye protection when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Since accessories, other
than those offered by D WALT, have
e
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT recommended
e
accessories should be used with
this product.
Separate collection. This product must
not be disposed of with normal
household waste.
WALT product
e
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces
the demand for raw materials.
english
29