Drive Medical RTL12605 Guia De Inicio Rapido página 2

assembly instructions
Weight capacity 300 lbs (136 Kg)
E
G
C1
A- Short Thumb Screw (5)
B- Large Thumb Screw (4)
C- Leg Receivers (2)
D- Seat (1)
1. Remove contents from carton and verify that all
parts in the parts diagram/list are present.
2. Place seat upside down on a flat surface so holes
are showing.
3. Align the leg section that has the concave area on
the underside with the holes in seat (Figure 1).
Align the leg section that has the concave area on
the top side with the leg section below (Figure 2).
F
G
D
C2
A B
E- Backrest Frame (2)
F- Backrest (1)
G- Legs (4)
Figure 1
Figure 2
4. Secure in place through the center hole using a
SMALL thumb screw (A) (Figure 3).
E
5. Attach backrest frame (E) to the seat by aligning
holes on backrest frame supports with the holes on
the leg receivers (C). Secure in place using the large
thumb screws (B), making sure to pay attention to
the "rear" of the seat (Figure4).
6. Insert legs (G) into leg frames by depressing push
pins, sliding legs over the receptacle and setting to
desired height. Make sure all the legs are set to the
same height (Figure 5).
Figure 3
Figure 4
Figure 5