Kuppersbusch DW9800.0 Instrucciones De Uso E Instalación página 17

1- Timer
2- Reduce fan speed
3- Display
4- Increase fan speed
5- Light
Program the working time
1) Switch on the cooker hood and choose
the required aspiration speed.
Before carrying
maintenance activities, ensure that the
extractor is disconnected from the mains.
To carry out cleaning and maintenance,
follow the Safety Instructions.
Fire risk exists in case that cleaning does not
take place according to the instructions.
Filter cleaning
To withdraw the filters from their locations
release the anchoring points. Clean the filter,
either by putting it in the dishwasher (see
notes) or leaving it standing in hot water to
simplify the removal of grease or, if wished,
by means of special sprays (protecting the
non metallic parts). Once clean, leave it to
dry.
Attention: the cooker hood will not work
until the main filter was reinstalled.
Notes: cleaning in the dishwasher with
aggressive detergents may blacken the
surface of metallic parts, without this
affecting its gas retaining properties.
N.B. The filter must be cleaned at least once
a month depending on how often the
extractor is used. It must be remembered
out any cleaning
3) Select the required programming time
from 1 to 99 minutes by using the buttons
-
4) The display will show the remaining
programming time.The maximum speed
be changed automatically to the second
speed level after 7 minutes.
 When the sign
is on, the filters should be cleaned.
 After cleaning the filters, simultaneously
whereupon the sign will be switched off.
or that grease is deposited in the extractor
when cooking, whether it is switched on or
not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor,
paying special
Afterwards, dry it using a lint-free cloth.
Note:
 Never use metallic scouring pads or
abrasive products that could damage
the surface.
 Do not use scrapers with metallic
surfaces such as knives, scissors etc.
Activated charcoal filter
 To install the charcoal filter, please
follow the instructions supplied with it.
 The carbon filter lasts from three to six
months depending on the particular
conditions of use.
 The activated carbon filter can neither
be washed nor regenerated. Once it is
exhausted, it must be changed.
english
-
attention to the grids.